Here’s instant protection for any kind of messy job. Before you start, just unroll enough rosin paper from this jumbo paper towel holder to protect your workbench. The thick paper absorbs all the glue or finish. When the paper gets too dirty, tear it off and throw it away. A roll of rosin paper is 170 ft. long, so one will last a long time. Here’s how to build your paper holder:
Buy a roll of rosin paper ($8) and a length of 1-1/2-in. pipe ($12 for a 4-ft. length) at a home center. Round up some scrap lumber and get ready to do a little bit of head scratching to customize a bracket arrangement that works with your bench design. Our setup should give you the general idea. Bore 1-7/8-in. holes in the scrap wood brackets. Screw keeper strips over the holes to keep the pipe from falling out as you unroll the paper. Use a handsaw to cut the paper roll and a hacksaw to cut the pipe to match the width of your bench. Then load the roll and start dripping stuff all over it.
Thanks to James Pauch for this idea.
Original article and pictures take http://www.familyhandyman.com/DIY-Tools---Tips/DIY-Workshop/Shop-improvements/rosin-paper-workbench-cover site